TSURUMI 110V 1″ Puddle Pump


£499.00 + VAT

The Tsurumi 110v Puddle Pump can be submersed in water found on flat surfaces and can pump large or small areas. It has the ability to pump water down to 1mm and thanks to its dual position outlet port, the user can place the hose in a position suited to their needs. This will ensure the hose does not kink.

The Tsurumi 110v Puddle Pump is constructed of a pressed steel outer casting, cast aluminium pump stand and steel and rubber base plate. It has a rubber pump chamber and urethane vortex impeller to protect it from sand and silt in suspension.

Other features of the Tsurumi 110v Puddle Pump include an integral check valve, 403 stainless steel shaft which is fitted with a double silicon carbide mechanical seal, an oil chamber with oil lifter, and an air cooling route to the top outlet allowing the pump to operate with no or a small amount of water. It has a flow rate of 170 liter per minute.


Delivery Information & Exclusions.

* UK Mainland Delivery, Delivery price above Excludes Northern Ireland, Northern Scotland & Isles, West Wales, coastal areas Etc Price On Application (POA).

*For none UK Deliveries POA.

*Offloading of heavy items such as bowsers & tanks should be made by a forklift with extended forks or similar heavy lifting equipment. If you will be offloading via an overhead crane and require delivery to be made on flat bed vehicle please advise prior to purchase as additional charges may apply, our standard delivery vehicles are normally curtain sided vehicles and don’t allow access for overhead cranes. If a forklift with extended forks is not available to offload, please advise prior to purchase as we can make alternative arrangements i.e. Via HIAB Delivery. However, these special deliveries will be POA.

*Delivery is a kerbside service only, and not a “drop at your door service”. Arrangements must be made by the customer to manoeuvre the tanks into position.

* It is the customers responsibility to ensure that there is safe and adequate access for large lorries.

*Trailer Engineering Will contact you prior to despatch to advise delivery date, if for any reason delivery is attempted and failed on the advised date, it is the customers responsibility to cover the initial transport costs and any additional charges to get the units back to ourselves and Re-delivered on another date. Therefore, it is vital that if delivery is expected on a specific date that someone is available with the correct offloading facilities and can sign for the goods at the delivery address as additional charges for failed deliveries can be significant.

*As offloading is the customers responsibility any damages to the units which is caused during the offloading process wouldn’t be covered under warranty and would be the customers responsibility.

*Tanks cannot be left without a customer’s signature.

Got a question?

Or simply need to know more about our 950 litre U.N. approved bunded diesel road tow fuel bowser?

    By clicking the send button below you are agreeing to Trailer Engineering Limited's Privacy Policy